Santa Ana, CA · Licensed & Insured · 2-Year Warranty

Bathtub Reglazing in Santa Ana, CA

Stained, chipped, rusted or just the wrong color? We refinish your existing bathtub in place to a smooth, glossy, like-new surface in a single day, for a fraction of what a replacement costs. Serving every Santa Ana neighborhood since 2015, with a written 2-year warranty.

10+Years experience
2-YearWritten warranty
1 DayTypical job time
Bathtub reglazing service in Santa Ana, California
  • 10+ Yearsof experience
  • 2-Year Warrantyon every service*
  • Licensed & InsuredCalifornia contractor
  • Same-Dayappointments available
  • Free Estimateswritten, no obligation

*Kitchen sinks carry a 6-month warranty because of the heavier daily wear they take.

Refinished white bathtub in a Santa Ana home bathroom
2-Yearwritten warranty

What Is Bathtub Reglazing?

A new surface on the tub you already own

Bathtub reglazing, also called refinishing or resurfacing, rebuilds the surface of your existing tub. We repair damage, strip and etch the old finish, prime it, and spray on a new acrylic urethane coating that cures into a hard, glossy shell. The tub stays exactly where it is. No demolition, no plumber, no tile work, no dumpster in the driveway.

It is the right choice for most bathtubs in Santa Ana: the original cast iron and porcelain tubs in Floral Park and French Park bungalows, the steel tubs in 1950s and 60s tract homes around Morrison Park and Sandpointe, and the fiberglass units in condos and apartments across the city. If the tub is structurally sound, we can make it look new.

  • Porcelain, cast iron, steel, fiberglass and acrylic tubs
  • Chips, rust, cracks and worn enamel repaired as part of the job
  • Color changes from vintage pink, blue, yellow or almond to white
  • Clawfoot and freestanding tubs refinished inside and out
  • Anti-slip floor texture available on request

Common Problems We Fix

If your tub looks like this, reglazing is the answer

Hard-water stains and yellowing

Orange County's hard water leaves mineral scale that no amount of scrubbing removes. Reglazing seals a fresh, stain-resistant surface over it.

Chips and rust around the drain

Once the porcelain chips, water reaches the steel or iron underneath and rust spreads. We grind out the rust, fill the chip and seal it for good.

Rough, dull or etched surface

Years of abrasive cleaners wear the glaze down until the tub feels like sandpaper and never looks clean. A new topcoat restores the gloss and the feel.

Outdated colors

Pink, mint, harvest gold and almond tubs date the whole bathroom. A color change to bright white costs a fraction of a remodel.

Peeling DIY refinishing kits

Store-bought epoxy kits peel within months. We strip the failed coating completely and do the job properly with commercial materials.

Rental turnover

Landlords and property managers in Santa Ana use us to make tubs rent-ready in one day instead of losing a week to replacement.

Our Process

How we reglaze a bathtub, step by step

A proper reglazing job is 80% preparation. Here is exactly what happens in your bathroom, usually in 4 to 6 hours.

  1. 01

    Inspection and masking

    We look at the tub material, chips, rust and the condition of the drain and overflow, then mask walls, floor and fixtures and set up outside-venting exhaust.

  2. 02

    Deep clean and etch

    Industrial cleaners strip soap scum, body oils, silicone and hard-water scale. The surface is then chemically etched so the primer has something to bite into.

  3. 03

    Repairs and sanding

    Chips, cracks and rust pits are filled with a two-part filler, sanded flush and feathered so you will not find them later. The whole tub is sanded for adhesion.

  4. 04

    Bonding primer

    A dedicated adhesion primer chemically links the old porcelain or fiberglass to the new finish. Skipping this step is why cheap reglazing peels.

  5. 05

    Topcoat

    Multiple thin coats of acrylic urethane are sprayed for an even, high-gloss, factory-style finish. Optional anti-slip texture can be added to the floor of the tub.

  6. 06

    Cure and walkthrough

    The finish is tack-free in hours and ready for use in 24 to 48 hours. We walk you through care instructions and leave your written 2-year warranty.

Reglazing vs. Replacement

What a new bathtub really costs in Santa Ana

A replacement is never just the tub. Here is the realistic comparison for a standard alcove bathtub.

Typical ranges for Santa Ana and Orange County. Your written quote is free and exact.
ReglazingReplacement
Typical cost$500 – $1,200$3,000 – $8,000+
Time in your home4 – 6 hours3 – 7 days, often longer
Demolition and disposalNoneTub, surround tile, sometimes drywall
Plumbing and permitsNot neededUsually required
Bathroom usable again24 – 48 hoursAfter the whole project is done
Expected life10 – 15 years20+ years
Warranty2 years, writtenVaries by installer

See the full savings breakdown

Our Warranty

Backed in writing for 2 full years

Every reglazing service we perform in Santa Ana is backed by a written 2-year warranty on workmanship and finish. If the coating peels, bubbles or fails because of our prep or application, we come back and make it right at no cost. The only exception is kitchen sinks, which carry a 6-month warranty because of the heavier daily wear they take from pots, pans and dishes.

  • Written warranty handed to you on the day of service
  • Covers peeling, bubbling, cracking and loss of adhesion caused by our work
  • Simple care instructions so the finish lasts well beyond the warranty

Care Guide

How to keep a reglazed tub looking new

The finish is tough, but it is not indestructible. Follow these simple habits and your tub will stay glossy for well over a decade.

Do

  • Clean weekly with a non-abrasive liquid cleaner and a soft cloth or sponge
  • Rinse and wipe down after use so hard water cannot dry on the surface
  • Fix dripping faucets promptly
  • Use a bath mat without suction cups, and remove it after bathing

Avoid

  • Abrasive powders, scouring pads and magic erasers
  • Suction-cup mats, which pull the finish up over time
  • Leaving shampoo bottles or metal cans standing on the tub floor
  • Bleach, drain cleaner or acid-based cleaners sitting on the surface

Service Area

Bathtub reglazing across every Santa Ana neighborhood

We are based in Santa Ana and drive to you. Most appointments inside the city are scheduled within a few days, and same-day service is often possible for single fixtures. We regularly work in these neighborhoods and ZIP codes:

Santa Ana neighborhoods

  • Downtown Santa Ana
  • Floral Park
  • West Floral Park
  • French Park
  • Park Santiago
  • Washington Square
  • Wilshire Square
  • Morrison Park
  • Saddleback View
  • Sandpointe
  • South Coast Metro
  • Delhi
  • Artesia Pilar
  • Riverview
  • Mabury Park
  • Thornton Park
  • Willard
  • Cabrillo Park
  • Portola Park
  • Fairhaven
  • Casa Bonita
  • Eastside

Santa Ana ZIP codes

92701, 92703, 92704, 92705, 92706, 92707

Nearby cities

  • Tustin
  • Orange
  • Garden Grove
  • Fountain Valley
  • Costa Mesa
  • Irvine
  • Anaheim
  • Westminster
  • Huntington Beach
  • Newport Beach

FAQ

Bathtub reglazing questions from Santa Ana homeowners

Still have a question? Call (714) 439-5614 or request a free quote and we will answer it directly.

Most standard bathtubs in Santa Ana fall in the $500 to $1,200 range, depending on the tub material, how much chip and crack repair is needed, and whether you want a color change. A new tub installed with demolition, plumbing and tile work typically runs $3,000 to $8,000 or more. Every quote we give is free, written and good for 30 days.

With normal care, a professionally reglazed tub lasts 10 to 15 years. The finish is a two-part acrylic urethane, the same family of coatings used on cars and aircraft. The main things that shorten its life are suction-cup bath mats, abrasive cleaners and leaving standing water on the surface.

The coating is dry to the touch in a few hours and ready for light use after 24 hours. We recommend a full 48 hours before the first bath or shower so the finish reaches full hardness. We confirm the exact time when we finish the job.

Yes. We reglaze porcelain-on-steel, enameled cast iron, fiberglass, acrylic and cultured marble tubs. Fiberglass and acrylic units get extra attention to any cracks or soft spots before the coating goes on. See our fiberglass enclosure page for one-piece tub and shower units.

There is a solvent odor during application. We seal off the bathroom, run an exhaust fan that vents outside, and use a respirator-grade setup. Most of the smell is gone within a few hours, and we ask that children, pets and anyone sensitive to fumes stay out of the room until the next day.

Yes. White and biscuit are the most common requests, but we can match almond, bone, gray and most standard fixture colors. Color changes on vintage pink, blue, green or yellow tubs from older Santa Ana homes are something we do regularly.

Always. Chips, rust spots, worn-through enamel and hairline cracks are filled, sanded flush and primed as part of the standard job. Repairs are included in the quote, not billed as surprises later.

Get your Santa Ana bathtub reglazed this week

Send a few details and a photo of the tub and we will reply with a written quote within one business day. Same-day appointments are often available.

Mon–Fri 8am–6pm · Sat 9am–4pm · Sun closed

Call us now(714) 439-5614 Get a free quoteReply within one business day